Rosewill RC200 user manual ＊To Verify Windows 98SE/ME Installation

ULTRA ATA/133 PCI RAID Card RC200 User Manual

8.Click Next again, then Finish.

9.Restart Windows to complete driver installation.

＊To Verify Windows® 98SE/ME Installation

1.Right-click My Computer, then click Properties, Select Device Manager tab.

2.Double click SCSI Controllers, Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller should be listed.

3.Highlight Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and click Properties. A message this device is working properly is displayed in the dialog box, the driver has been correctly installed. If any error message is displayed, remove Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and restart your system.

For Windows® NT 4.0

＊For New Windows® NT 4.0 Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the “RC-200\raid” folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows® NT 4.0 installation.

2.Install the board and follow Microsoft procedures to install Windows NT 4.0 accordingly.

3.At the Windows NT Setup screen, press F6 to specify and add the driver.

4.Press S, select Other, then press Enter.

5.Insert the driver diskette and press Enter.

6.Select Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and press Enter.

24