Rosewill RC200 user manual floppy disk then follow the directions below

ULTRA ATA/133 PCI RAID Card RC200 User Manual

copy the contents of the “RC-200\raid” folder, found on the driver CD, onto a blank

floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows installation.

2.Install the board and follow Microsoft procedures to install Windows ®2000 accordingly.

3.Restart your system when prompted during Windows’ installation.

4.At the Windows 2000 screen, press F6 to install the driver.

5.Insert the driver diskette. Press S, then press Enter.

6.Select Silicon Image SiI 0680 ultra-133 Medley ATA Raid Controller and press Enter.

7.Press Enter to continue and follow on-screen instructions to complete installation.

＊For Existing Windows® 2000 Installation

1.Setup the RAID Array prior to driver installation.

2.Install the board and boot up Windows® 2000.

3.At the Found New Hardware Wizard, click Next.

4.Select Search for a suitable driver for my device(recommended) and click Next.

5.Check the option Specify a location and then click Next to continue.

6.Insert the driver CD into CD ROM Drive, and they type D:\RC-200\raid (Note: “D:\” represents the drive letter assigned to the CD-ROM drive you are using. If D is not letter of your CD-ROM drive, substitute D with the correct drive letter), then click OK.

7.Click Next again, then Finish.

8.Restart Windows to complete driver installation.

26