RTS DKP-8 manual Menus, Autodial for KP-12/DKP-12 Only, Keypanel Menus in Menu Mode

Menu Mode

Table1. Keypanel Menus in Menu Mode

AUTODIAL	KEY ASGN	KEY OPT	SERVICE
page 26	page 27	page 35	page 38
	AUTODIAL	BTN LOCK	DIMMER
	AUTOFUNC	CHIME	FOOT SW
	CLEAR	CLR OPT	KEY TYPE
	COPY	COPY	LOCK
	LISTS	GROUP 1	MIC CTRL
	ICOMa	GROUP 2	MIC COMP
	PL	GROUP 3	MIC GAIN
	IFB	GROUP 4	MOD ASGN
	IFSL	LATCHING	MUTE LVL
	ISO	SOLO	OPTO ISOb
	P-P		OUT CTRL
	RLY		RESET
	SPCL		SAVE CFG
	UPL		SET ADDR
	PHONE		SIDETONE
	REDIAL		TALLY
			TEST PNL
			TONE
			USM

a.ICOM is only available for trunked intercom systems.

b.LOCAL I/O and OPTO-ISO are available only with the optional GPI module installed (KP-12 only).

Menus, Autodial (for KP-12/DKP-12 Only)

NOTE: This menu is used to store autodial numbers. To assign a key that dials a specific autodial number, see page 27. To use stored autodial numbers with an all-purpose phone key see page 14.

Store autodial numbers as follows:

1.All phone keys (including autodial or redial keys) must be OFF.

2.When you select AUTODIAL, the call waiting window will display DIAL NUM.

3.If your phone system requires you to enter a digit to request an outside line, enter that digit first. Some phone systems may also require a brief pause after the request for an outside line. If this is the case, enter *99 after the first digit to create a pause.

4.Finish dialing the telephone number.

5.When finished dialing, tap the SELECT control. The call waiting window will then display TAP 0-9.

6.Tap a single key (0 through 9) to assign the telephone number to autodial number 0 through 9.

7.After an autodial number has been assigned, the call waiting window will again display DIAL NUM.

8.Repeat steps 3 through 6 to store additional autodial numbers.

9.Press and hold the SELECT control for two seconds to return to the top-level menu when you are finished entering autodial numbers.

26