RTS DSI 2008 Audiocom Audio Connection, Using a TW-5W to connect to two TW channels to the DSI

NOTE: The DSI 2008 features internal DC isolation. You can therefore connect to the DSI 2008 to powered TW cables, and it will not draw any power from the TW system.

2.On the DSI 2008 front panel: For System A and System B, set the 2W CHAN SEL switch to the appropriate position. To interface to TW channel 1 select position 1; for TW channel 2, select position 2.

NOTE: If the System A or System B will not be used, set the 2W CHAN SEL switch to the OFF position and attach a dummy load to the TW XLR connector.

FIGURE 3. Using a TW-5W to connect to two TW channels to the DSI 2008

Audiocom Audio Connection

1.You can directly connect standard Audio 1-channel cables. Connect one Audiocom channel to the J1A connector on the back of the DSI 2008 (System A). Connect a second Audiocom channel to the J1B connector (System B). If your Audiocom system uses

2-channel cables, use a JB-2 Junction Box to split the channels (Figure 4)

NOTE: The DSI 2008 features internal DC isolation. You can therefore connect the DSI 2008 to powered Audiocom cables, and it will not draw any power from the Audiocom system.

2.On the DSI 2008 front panel, set the 2W CHAN SEL switches for System A or System B to the BAL position.

NOTE: If System A or System B hybrid will not be used, set the 2W CHAN SEL switch to the OFF position and attach a dummy load to the TW XLR connector.

8