INSTALLATION AND SETUP
2.7 Mounting
For typical front or rear floor mounts, mount the projector on a secure table
or cart. Take care with a mobile cart-avoid sudden stops, excessive force and
uneven surfaces that may cause the projector and cart combination to over-
turn.
The table or cart should be reasonably level. Fine adjustments to the projec-
tor level can be made by adjusting the height of the projector legs.
Special Mounting
Note that projector can be rotated and mounted at any vertical angle-i.e., you can tilt the face of
the projector up or down as much as desired for your installation. The side-to-side tilt, however,
must not exceed 15° (see below). This limit ensures that the arc lamp in the projector operates
properly and safely. Always make sure that exhaust air from the projector does not vent towards
the lens, otherwise you may detect heat waves in your projected image.
Horizontal and Vertical Tilt Ranges
You must use the proper ceiling mount fixture or stacking kit for your projector. For more infor-
mation, contact your Runco Dealer.
Maximum Horizontal Offset (ALL LENSES)
2-11