INSTALLER OPTIONS
Use the "Installer Options" submenu to select a test pattern or to
freeze the current image, both helpful for closely examining per-
formance. You can also turn specific colors on or off to further pin-
point where a suspected problem may be occurring.
Test Patterns
Use the pull-down list to select and display an internal test pattern. Select
OFF to turn off the display of a test pattern.
NOTE: For quicker access from your presentation, use the key to
cycle through the patterns. At the last pattern, press to return to your
presentation-or press at any time.
Freeze Image - Use the “Freeze Image” checkbox to freeze (stop) the image at a single frame.
This diagnostic tool is useful if you need to examine in detail a still version of the incoming image
that may not be “freezable” at the source. For example, in moving images it is difficult to observe
artifacts such as external deinterlacing/resizing and signal noise.
DMD Enable
Select which color or colors you want to see, set to G DMD for focusing the projector.
NOTES: 1) Input levels apply for the current source only, but for any color temperature used.
2) Assuming that color temperature has been set up based on the internal test patterns, you can
then set up input levels for a given source so that it matches the color temperature of the internal
test patterns.
Test Pattern
Freeze Image
DMD Enable
3-30
Test
Exit
Test
None
ANSI
16 Scale
All White
All 50%
All Black
Pixel Align
ANSI 13 Pt
Setup and Focus
OPERATION