The BLANKING function allows you to 'cut off' part of the image to fit the screen properly, or to eliminate
anomalies on the extreme outsides (usually the top) of the image. This can be done to the top, bottom,
left or right sides individually.
To adjust BLANKING, highlight the desired area you wish to blank (top, bottom, left or right), and use the
left and right arrows to make the adjustment.
Most CRT projectors themselves have blanking controls, and it is recommended that you use the
controls on the projector as opposed to the processor, if possible. In the event that your display device
does not have blanking controls, however, use the blanking controls provided in the processor.
In the event that your VHD Ultra Controller appears to have a software problem, or adjustments have
been made so far out of range that the image is no longer on-screen or discernable, you can reset the
processor back to factory values. This sets ALL settings back to factory values, so any adjustments made
previously will be lost.
To reset your VHD Ultra Controller, follow this procedure:
·Turn off the MAIN POWER switch on the back of the processor
·Hold down the DOWN ARROW button, and turn the MAIN POWER SWITCH back on.
Continue holding the down arrow button until the LED on the front panel blinks, then release
the down arrow button.
Once this is done, your processor has been completely reset to factory values.
After resetting the unit, Composite video will be the active source.
SYSTEM RESET is not on any of the menus; it must be performed using the instructions above.
Blanking
Top 131
Bottom 707
Left 241
Right 1292
Blanking
System Reset
6-15