INSTALLATION AND SETUP
2.2 Installing The Lens
A variety of lenses are available to accommodate different throw distances and specific types of
installations. See page 2-10 for details. To change/install a lens, follow the steps below.
NOTES: 1) You will need a 9/64”(3mm or 3.5mm) hex socket ball driver (supplied with projec-
tor) or allen wrench for this procedure. 2) “Top” or “bottom” references assume a non-inverted
projector, as illustrated. 3) If you are installing a lens, first make sure its Lens Adapter is present
on either the lens or projector. Such an adapter/flange secures to the projector in the same man-
ner as the flange described below, but accommodates a screw-mount lens.
STEP 1Turn off the projector, cool, and unplug.
Before removing or installing a lens, turn off the
projector and allow it to cool for five minutes before
unplugging. Make sure that the lens cap is on.
WARNING
Unplug the projector.
Install the lens cap.
STEP 2Loosen the 3 lens mount screws
IF FIXED LENS: Use the hex socket ball driver
provided with the projector to loosen the 3 lens mount
screws that secure the lens flange to the mount-loosen
these screws only, do not remove.
Install Lens Cap
!
Loosen 3 screws
- FIXED LENS -
2-2