Trigger Connections
Page Trigger IN
The page trigger can be used to trigger a page event. The 12VDC trigger input overrides signal sensing and selects the audio input from Source 8 (if included in page event) and sends it to any zone that does not have page disabled or that is not in Do Not Disturb mode. Do not use the page trigger input if there is a regular audio source connected to Source 8.
Note: The diagram at right shows an optional cable to the 12VDC trigger in from the phone system - this will initiate the page in the event that the volume or signal is too low initially to activate the line level input.
Paging Audio IN/OUT
The
Note: If Source 8 is enabled for paging events then only seven source inputs are available.
The audio input has signal sensing for the paging circuit which will indicate when an audio signal is present. There is a gain control knob above this input for setting page input sensitivity.
Tip - Pos (+)
3.5mm Plug
Sleeve - Neg
Polarity of 3.5mm Plug
12VDC trigger cable
Mono RCA | (optional) | |
audio cable | ||
|
Phone system
Typical Paging Configuration
(if using source 8 for paging events)
Russound | 23 |