Remote Control - Programming
Using Learning
The
•The original remote control must be in working order and available for learning to work properly.
•Learned keys are mode specific, so each one can store a unique function for each mode.
•Do not use the following keys for learning: Device Keys, SET, Back, or Record.
•Learning capacity is approximately 40 to 100 keys, depending on the code being learned.
•Certain device codes are not learnable including
•For optimum learning, avoid high levels of ambient light such as natural sunlight or
Programming a learned key
Note: If more than 15 seconds pass between key presses, the remote exits programming.
1.Press and hold SET until LED flashes twice.
2.Press
3.Press a device key once to assign a mode for learning.
4.Place the
5.On the
6.On the original remote, press and hold the the key to be learned. The
Note: If the LED displays one long blink, a learning error has occurred. Try repeating this step again until a successful capture occurs. If the function is still not captured, press and hold SET to exit programming. Review the learning precautions listed above, or the Troubleshooting tips below, before beginning again at step 1.
7.Repeat steps
Deleting a single learning key
1.Select a source.
2.Press and hold SET until the LED flashes twice.
3.Press
4.Press the key (twice) containing the learned function to be deleted. The remote blinks twice.
5.Repeat steps
Deleting all learned keys in a specific mode
1.Press and hold SET until the LED blinks twice.
2.Press
3.Press a device key twice to delete all the learned keys for that mode. The LED blinks twice.
4.Repeat steps
Changing Volume Lock
The
Locking Volume Control to One Mode (Global Volume Lock)
1.Press and hold SET until the red LED blinks twice, then release.
2.Enter
Unlocking All Volume Control (Restoring Global Unlock)
1.Press and hold SET until the red LED blinks twice, then release.
2.Enter
Unlocking a Single Device’s Volume Control
1.Press a device key (VID, DVD, etc.).
2.Press and hold SET until the red LED blinks twice, then release.
3.Enter
30 | Russound |