Russound MCA-C5 installation manual Keypad Color Plate Conversion, MDK-C5Color Plate Conversion

Keypad Color Plate Conversion

MDK-C5 Color Plate Conversion

You will need both small straight and Phillips head screwdrivers to change the color plates on the keypad. The Bezel Molding and the Trim Plate will be switched for the new color plates.

1.If installed, remove the MDK-C5 keypad from the wall. Gently pull the Trim Plate off the mounting plate. Unscrew the unit from the electrical box, and disconnect the cable.

2.Unscrew the plastic Frame Plate. Keep the Frame Plate and screws for reattachment later.

3.Remove the Display Lens from the Bezel Molding by providing inward pressure to the two locking tabs while simultaneously pushing it away from the Bezel Molding.

4.Once the Display Lens is removed, put aside for reattachment later. Be careful to not damage the display.

5.Remove the Bezel Molding by gently pressing in each of the 4 locking tabs (2 per side) while pushing it away from the metal frame.

6.Reverse the order for installation, taking the following precautions.

a.Make sure the button key mat is positioned properly on the front circuit board and without dust or debris on the button contact points prior to attaching the Bezel Molding.

b.Make sure that there isn’t any debris or fingerprints on either the display or back of the Display Lens prior to reattachment.

c.Use a clean, dry, lint-free soft cloth to gently wipe the display or back of the Display Lens to clean if necessary. Never use cleaning agents as this can cause streaking or permanent damage to either part.

Screws

VOL VOL

HOME

MENU

Metal Frame

Bezel Molding Display Lens

Frame Plate	Screws
	Trim Plate

Keypad Disassembly / Assembly

16 Russound MCA-C5 User and Installation Manual