ST2-RC Remote Control Operation
The
Turning the unit on/off
To switch the ST2 tuner in or out of standby mode,
PWR
push or any other button except TUNER 1 or TUNER 2.
Selecting the desired tuner
To control a tuner, push TUNER 1 or TUNER 2 . When pressed, these buttons will be backlit green for Tuner 1 (XM1) and amber for Tuner 2 (XM2). Each time a tuner is selected the display will refresh with the cur- rent station or preset for that tuner, and all subse- quent button presses and memory preset entries will be associated with that selected tuner.
Selecting the desired channel
|
|
| TUNE |
|
|
Use | TUNE | and | for manual tuning. To move quickly | ||
through the channels, press and hold either of the | |||||
Tune buttons for more than 1.5 seconds. |
| ||||
To directly select a channel, press | TUNE | , and enter | |||
| |||||
the two- or | |||||
Selecting an XM mode |
|
| |||
Push | OK to select an XM operating mode. |
Exiting an XM mode
ST/
Push MONO to exit the XM operating mode selection menu.
Recalling a Memory Preset
To recall a memory preset, select the desired tuner,
press | BANK | and enter the desired bank number | ||
| ||||
MEM | and enter the desired preset | |||
|
number (1 to 6). The memory presets can also be
|
|
| MEM |
accessed by using | MEM | and | to scroll through all |
presets for the selected bank.
Saving Favorites
The remote control stores two “favorites” (similar to memory presets) per tuner. These are set simply by selecting either Tuner 1 or Tuner 2, setting the
desired frequency and pressing and holding FAV 1 or
until “FAV1 (2) saved” appears on the tuner. Stored Favorites are then recalled by pressing either
FAV 1 or FAV 2 .
19