Russound ST2-XM2SETUP AND CONNECTIONS, Basic Connections, ST2-KP RJ-45Connection Wiring, Power

ST2-XM2 SETUP AND CONNECTIONS

BASIC CONNECTIONS

Power

To power the tuner, connect the 12VDC external power supply by inserting the power supply jack into the power supply connection on the tuner’s rear panel.

Audio Output

Connect one end of a dual RCA audio cable to the Tuner 1 Audio Output connection. Keep prop- er channel identity. Attach the other end of the RCA cable to the source input of the audio con- trol system. Repeat the same procedure for the Tuner 2 Audio Output.

IR Connections

The ST2-XM2 Tuner can be controlled by infrared commands received through the two IR connections on the rear panel. The ST2-XM2 Tuner component contains two tuners, which must be set up as two sources. There are two IR connections - one for each tuner in the ST2-XM2. You will need two IR link cables (Russound P/N 09-0508) for these connections. There is a unique IR code set each for Tuner 1 and Tuner 2, which allow each to be controlled independently. These codes can be learned from the ST2-RC remote into learning-capable remote controls and keypads.

If you are using an IR-controlled system from another manufacturer, installation should be similar. The ST2-XM2 IR codes may be learned into many other manufacturers’ remote controls that have learning capability for unified control over the A/V equipment.

RNET Connection

To link the ST2-XM2 to an RNET-compatible device, use a CAT-5 passthrough patch cable with similar wiring terminations at each end. Connect one end of the cable to the RNET Link In of the ST2 tuner, and connect the other end of the patch cable to the RNET Link Out connec- tion on the RNET-compatible device.

ST2-KP RJ-45 Connection Wiring

ST2-KP Keypad to ST2-XM2 Connection (Non-RNET System)

The ST2-KP connects to the ST2-XM2 tuner with CAT-5 cable, using an RJ-45 (T568A) jack on the tuner connection end of the cable. Be sure to use the keypad ports for the ST2-KP and NOT the RNET link ports. The ST2-XM2 tuner sup- ports up to two ST2-KP keypads. An SA-ZX3 Keypad Splitter can be used to add additional keypads.

Note: ST2-KP keypads are designed for use with IR-controlled systems (non-RNET systems). When the ST2-XM2 Tuner is a component of an RNET system such as CAV6.6, the RNET-system keypads are used.

Rack Mount Installation

The ST2-XM2 can be mounted in a standard component rack using the rack ears provided. Line the rack ear’s two rows of screw holes with the three screw holes on the side of the tuner. Use the screws provided to secure the rack ears onto the unit on both sides. The ST2-XM2 tuner should not be installed above a high heat- producing component such as a power amplifier.

9