Russound ST2-XM2 Update Firmware Chassis, Factory Initialization Chassis, System Info Chassis

ST2-XM2 TUNER PROGRAMMING

ST2 TUNER SETUP MENU

Update Firmware (Chassis)

The Update Firmware procedure allows the ST2 tuner’s OS firmware to be updated. The proce- dure is performed using a DB9 serial cable with one end connected to the RS-232 port on the back of the tuner and the other connected to a PC or laptop. If an OS firmware update is avail- able, it can be obtained through the Document Center at www.russound.com. XM tuner module firmware must be performed by an authorized Russound service facility.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.TUNER SETUP appears. Press MEM Up/Down until UPDATE FIRMW appears on the tuner.

3.Press BAND to enter the UPDATE FIRMW menu.

4.“Hold BAND” appears on the tuner.

5.While pressing and holding BAND, “After update cycle power” appears on the tuner display.

6.When “Start Update” appears on the tuner dis- play, start the update program. “Finished” appears on the computer screen when complete.

7.Cycle power to the tuner.

Factory Initialization (Chassis)

The Factory Initialization procedure allows the erasure of all programmed settings and returns them to the factory default settings.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.TUNER SETUP appears. Press MEM Up/Down until FACTORY INIT appears on the tuner.

3.Press BAND to enter the FACTORY INIT menu.

4.“Are you sure” appears on the tuner. Using the Tune Up/Down buttons, view the “Yes” and “No” selections.

5.Press BAND to select. A “No” selection

returns to the top of the Factory Init menu. A “Yes” begins the initialization.

6.“Please wait” appears on the tuner during the process and “Cycle Power” appears when com- plete.

7.Cycle power on the ST2-XM2 tuner.

System Info (Chassis)

The System Info menu shows the ST2 Tuner’s manufacturing build properties.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.TUNER SETUP appears. Press MEM Up/Down until SYSTEM INFO appears on the tuner.

3.Press BAND.

4.Press BAND at “Build Time” to view.

5.Press MEM Up/Down to advance.

6.Press BAND at “Build Date” to view.

7.Press MEM Up/Down to advance.

8.Press BAND at “Version” to view.

9.Press TNR SEL to exit the System Info menu.

(END OF ST2 CHASSIS SETUP)

26