Russound manual PROGRAMMING FOR CAM6.6 USE, ST2-XM2TUNER PROGRAMMING, Source Configuration Note

ST2-XM2 TUNER PROGRAMMING

PROGRAMMING FOR CAM6.6 USE

NOTE: The CAM6.6 firmware must be version 1.00.11 or higher and UNO-S1 firmware must be version 1.00.21 or higher to control the ST2-XM2 Tuner. Use the System Info Menu of the CAM6.6 to check the firmware version. If the firmware is not the proper revision as noted here, visit the Document Center at www.russound.com to obtain the latest version.

To Program the CAM6.6 (with no internal tuner) to operate with the ST2-XM2 Tuner: (refer to the CAM6.6 Instruction Manual for details)

1.Enter the Setup Menu by pressing the Setup button on the side of the UNO-S1 keypad.

2.SOURCE SETUP will appear. Enter the Source Setup Menu by pressing the Next button on the UNO-S1 keypad.

3.BASIC SETUP will appear. Enter the Basic Setup Menu by pressing the Next button again.

4.SOURCE NUM will appear. Use Volume Up and Volume Down buttons to select the source number to which Tuner 1 (XM) is connected. Press the Power button to enter your choice.

5.SOURCE NAME will appear. Use Volume Up and Volume Down buttons to select the name for the source (e.g., Tuner 1 or XM). Press the Power button to enter your choice.

6.COMMAND TYPE will appear. Select PERIPHERAL from the list. Press the Power button to enter this choice.

7.SAVE CHANGES? appears. Select “Yes” and press the Power button to save changes.

8.SOURCE NUM appears again. Repeat steps 4 through 7 to configure the second tuner.

9.Press the Setup button three times to back out of the Installation Menu.

To Program the CAM6.6 (with internal tuner) to operate with the ST2-XM2 Tuner: (refer to the CAM6.6 Instruction Manual for details)

If the CAM6.6 has an internal tuner installed in the Source 1 position, use sources 2 through 6 for the ST2-XM2.

Source Configuration Note:

When the ST2-XM2 Tuner is used with the CAM6.6 or other RNET controller, it is configured as an RNET command type “Peripheral” and is connected via the RNET bus. This makes the tuner behave as a fully integrated device with UNO-S1 and UNO-S2 keypad support. Each tuner must be set up with a unique source number (1 - 6) or unassigned. An unassigned tuner is not controlled by the RNET bus.

Key Function Note:

When using the tuner with the CAM6.6-S2 system, do not reassign keypad and remote buttons for tuner control in the CAM6.6 Key Configuration Menu. When the tuner is assigned the “Peripheral” command type in the CAM6.6 Setup Menu, key assignments and functions are automatically assigned and will operate as shown in the preceding UNO-S2 keypad and UNO-LRC1 remote diagrams.

33