![ST2-XM2 TUNER PROGRAMMING](/images/new-backgrounds/15654/1565449x1.webp)
ST2-XM2 TUNER PROGRAMMING
ST2 TUNER SETUP MENU
ST2-XM2 Tuner Setup Menus
Note: The Setup Menu procedures must be performed from the
The
If the
If the
1.ST2 Chassis Setup Menu - Assign source numbers to Tuner 1 and Tuner 2.
2.CAV6.6/CAM6.6 Source Setup Menu - Assign the corresponding source numbers to Tuner 1 and Tuner 2.
3.CAV6.6/CAM6.6 Source Setup Menu - Assign command type PERIPHERAL to Tuner 1 and Tuner 2.
NOTE: Once the programming procedures are completed, cycle power first to the Tuner and then to the CAV6.6/CAM6.6 (must be powered on last) to establish a connection.
ST2 Chassis Setup Menu
Source Number (Chassis)
The Source Number procedure permits Tuner 1 (XM1) and Tuner 2 (XM2) to be assigned the proper peripheral source identities as will be assigned in the CAV6.6/CAM6.6 Source Setup.
1.Enter the Setup Menu by pressing and holding the TNR SEL button.
2.TUNER SETUP appears. Press MEM Up/Down until SOURCE NUM appears on the tuner.
3.Press BAND. TUNER # appears.
4.Press the Tune Up/Down buttons to select the Tuner # (Tuner 1 is XM1, Tuner 2 is XM2).
5.Press BAND. SOURCE NUM appears.
6.Press the Tune Up/Down buttons to scroll through the source numbers
7.Press BAND to select the source number (as assigned in the CAV6.6/CAM6.6 setup process).
8.Repeat the process for the next tuner.
9.Press TNR SEL to exit the Source Number menu.
(continued)
25