Russound ST2-XM2 manual IR-controlledSystem, CAi Series, RS-232Controlled System, Box Contents

INTRODUCTION

Before using the ST2-XM2 tuner with the CAV6.6 or CAM6.6, you must assign source numbers to Tuner 1 and 2 in the ST2 Setup Menu AND complete the CAV6.6 and CAM6.6’s Source Setup procedure to identi- fy the tuner as a “Peripheral“ device and assign Source Numbers. The CAV6.6 requires firmware version 2.00.01 or higher to control each tuner through RNET. The UNO-S2 keypad requires firmware version 3.00.01 or higher.

IR-controlled System

CAi Series -

The ST2-XM2 Tuner can be controlled by infrared commands received through either of the two IR connections on the rear panel. There are two unique IR code sets for Tuner 1 and Tuner 2, which allow each to be controlled independently from either IR connection. These codes can be learned from the ST2-RC remote control into the CA-LRC1 remote control and/or the DSC and DAN IR learning keypads.

The ST2-XM2 contains two individual tuners, which makes it act as two sources in the CAi system. There are two source audio outputs and two IR connections - one for each tuner in the ST2-XM2. You will need at least one IR link cable (Russound P/N 09-0508) for these connections (one is supplied with each CAi system).

If you are using an IR-controlled system from another manufacturer, installation should be simi- lar. The ST2-XM2 IR codes may be learned into many other manufacturers’ remote controls that have learning capability for unified control over the A/V equipment.

Note: Optional ST2-KP keypads can be used to provide control for the ST2-XM2 Tuner and are designed to be used with IR-controlled systems.

RS-232 Controlled System

The ST2-XM2 Tuner can be controlled using the RNET protocol provided via the RS-232 port on the rear panel. It can also be controlled by any RS-232-enabled control system (e.g., Crestron, AMX). Information on RS-232 operation is avail- able to dealers on the Russound web site, www.russound.com.

BOX CONTENTS

The ST2-XM2 Tuner comes with the parts needed to setup and operate the component. These include:

•ST2-XM2 Tuner (two XM modules)

•ST2-RC remote control

•12VDC power supply

•XM antenna (2)

•RCA audio cable (2)

•Rack mount ears

Please call Russound at 800-638-8055 ext. 501 for assistance if parts are missing.

5