INTRODUCTION
INSTALLATION APPLICATIONS
When the ST2S Tuner is used with an RNET- enabled device such as the CAV6.6 and is con- nected to it through the Link In or Link Out port, the tuner will be controlled by the CAV6.6 through the
Before using the ST2S tuner with the CAV6.6, you must assign source numbers to Tuner 1 and 2 in the ST2 Setup Menu AND complete the CAV6.6’s Source Setup procedure to identify the tuner as a “Peripheral“ device and assign Source Numbers. The CAV6.6 (Rev. 3) requires firmware version 2.01.16 or higher and CAV6.6 (Rev. 4) requires firmware version
3.01.10or higher to control each tuner through RNET. The
IR-controlled System
CAi Series -
The ST2S Tuner can be controlled by infrared commands received through either of the two IR connections on the rear panel. There are two unique IR code sets for Tuner 1 and Tuner 2, which allow each to be controlled independently from either IR connection. These codes can be learned from the
these connections (one is supplied with each CAi system). If you are using an
Note: Optional
RS-232 Controlled System
The ST2S Tuner can be controlled using the RNET protocol provided via the
BOX CONTENTS
The ST2S Tuner comes with the parts needed to setup and operate the component. These include:
•ST2 Tuner (SIRIUS module, AM/FM module)
•
•12VDC power supply
•AM loop antenna (1)
•FM antenna (1)
•SIRIUS antenna (1)
•RCA audio cable (2)
•Rack mount ears
Please call Russound at
5