UNPACKING
1.Carefully remove all parts from the shipping carton.
2.Do not discard the packing material until you have identified all the parts in the parts list.
3.If all parts have been included, proceed to assembly.
4.If you are missing a part, contact your dealer to obtain it before attempting to assemble the tool.
5.Examine all the parts to make sure no breakage has occurred during shipping. Any damaged or missing part should be replaced before attempting to use the tool.
WARNING:
Do not allow familiarity with your drill press to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.
WARNING:
Do not attempt to assemble the drill press, plug in the power cord, or turn on switch if any parts are damaged or missing. Failure to heed this warning could result in serious personal injury.
LOOSE PARTS
2
1
3
|
|
|
| 9 | 13 |
|
|
|
| 4 | 11 | 14 |
|
| 6 |
|
|
|
|
|
| 12. |
|
|
|
| 15 |
| 17 |
|
| 8 |
|
|
|
|
|
|
|
| |
|
|
| 7 | 10 |
|
|
| 5 |
|
| 18 | 16 | Fig. 3 |
|
|
|
| |||
1. | Head Assembly | 11. Hex Wrench |
|
| ||
2. | Column | 12. | Table Crank Handle |
|
| |
3. | Table Assembly | 13. | Gear Rack |
|
|
|
4. | Table Lock Handle | 14. | Worm Gear |
|
| |
5. | Base | 15. | Column Collar |
|
| |
6. | Feed Handles (3) | 16. | Chuck |
|
|
|
7. | Chuck Key | 17. | Base Collar |
|
| |
8. | Pulley Housing Knob | 18. | Scale Set Handle |
|
| |
9. | M5 Pan Head Screw | 19. | Operator’s Manual (not shown) |
| ||
10. M8 1.25 Hex Bolts (4)
9
