ADJUSTMENTS
WARNING:
To prevent accidental starting that could cause possible serious personal injury, assemble all parts to your saw before attaching battery pack. Battery pack should never be attached to saw when you are assembling parts, making adjustments, installing or removing blades, or when not in use.
As mentioned previously your saw has been factory assembled and adjusted. The dust guide or dust bag, battery pack and blade are the only parts that have to be installed.
DUST GUIDE
See Figure 12.
■Remove battery pack from saw.
WARNING:
Failure to remove battery pack from your saw could result in accidental starting causing possible serious personal injury.
To install the dust guide, place the end marked INSERT over the exhaust port in the upper blade guard. Turn the guide so that the open end is facing down or toward the rear of the saw.
squeeze the two metal clips to open the mouth of the bag and slide it on the exhaust port. Release the clips. The metal ring in the bag should lock in one of the grooves on the exhaust port. For more efficient operation, empty dust bag when no more than half full. This will permit better air flow through the bag.
DUST BAG
METAL CLIPS
EXHAUST
PORT
R |
|
O T | O N |
A T I |
Fig. 13 |
WORK CLAMP
See Figure 14.
EXHAUST
PORT
DUST GUIDE
■Remove battery pack from saw.
WARNING:
Failure to remove battery pack from your saw could result in accidental starting causing possible serious personal injury.
To install work clamp, place the shaft of the clamp in either hole in front of the miter table base. Rotate the knob on the clamp to move it in or out as needed.
R O T A T I O N
Fig. 12
DUST BAG
See Figure 13.
■Remove battery pack from saw.
WARNING:
45
5 
4
62 . 31
30 22.5 
15
15
22.5
31.62 | 30 |
Failure to remove battery pack from your saw could result in accidental starting causing possible serious personal injury.
A dust bag is packed with your saw. It fits over the exhaust port on the upper blade guard. To install it, remove the dust guide from the exhaust port. Then,
WORK CLAMP | KNOB | Fig. 14 |
Page 15
