ADJUSTMENTS
■Depress the spindle lock button and rotate the blade bolt until the spindle locks. See Figure 18.
■Using the blade wrench provided, loosen and remove the blade bolt.
Note: The blade bolt has left hand threads. Turn blade bolt clockwise to loosen.
■Remove outer blade washer. Do not remove inner blade washer.
■Wipe a drop of oil onto inner blade washer and outer blade washer where they contact the blade.
WARNING:
If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly.
■Fit saw blade inside lower blade guard and onto spindle. The blade teeth point downward at the front of saw as shown in figure 17.
CAUTION:
Always install the blade with the blade teeth and the arrow printed on the side of the blade pointing down at the front of the saw. The direction of blade rotation is also stamped with an arrow on the upper blade guard.
■Replace outer blade washer. The double "D" flats on the blade washers align with the flats on the spindle.
■Depress spindle lock button and replace blade bolt.
Note: The blade bolt has left hand threads. Turn blade bolt counterclockwise to tighten.
■Using the blade wrench provided, tighten blade bolt securely.
■Remove the blade wrench and store it in a safe place for future use.
■Replace the lower blade guard and blade bolt cover.
■Retighten phillips screw securing blade bolt cover. Tighten screw securely. See Figure 17.
WARNING:
To prevent damage to the spindle lock, always allow motor to come to a complete stop before engaging spindle lock. Make sure the spindle lock button is not engaged before attaching battery pack.
TO REMOVE BLADE
See Figures 15, 16, 17, and 18.
■Remove battery pack from saw.
WARNING:
Failure to remove battery pack from your saw could result in accidental starting causing possible serious personal injury.
■Loosen the phillips screw on the blade bolt cover until blade bolt cover can be raised. See Figures 15, 16, and 17.
■Gently raise the lower blade guard bracket, releasing lower blade guard from notch so that lower blade guard and blade bolt cover can be rotated up and back to expose the blade bolt. See Figure 16.
■Depress the spindle lock button and rotate the blade bolt until the spindle locks. See Figure 18.
■Using the blade wrench provided, loosen and remove the blade bolt.
Note: The blade bolt has left hand threads. Turn blade bolt clockwise to loosen.
■Remove outer blade washer. The blade can now be removed.
Your compound miter saw has been adjusted at the factory for making very accurate cuts. However, some of the components might have been bumped out of alignment during shipping. Also, over a period of time, readjustment will probably become necessary due to wear. After unpacking your saw, check the following adjustments before you begin using saw. Make any readjustments that are necessary and periodically check the parts alignment to make sure that your saw is cutting accurately.
SPINDLE LOCK
BUTTON
3
0
22
. 5
1 5
0
1 5
22.5 |
|
3 0 |
|
31.62 | 4 5 |
|
Fig. 18
Page 17
