Warning
WARNING: To prevent fire or shock hazard, do not expose the unit to rain or moisture.
CAUTION: To avoid electrical shock, do not open the cabinet. There are no user serviceable parts inside. Refer servicing to qualified personnel only.
This symbol is intended to alert the user of the presence of
This symbol is intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliances
WARNING: Any adjustments made to this unit may alter the performance and can result in hazardous radiation exposure.
ξDo not attempt to clean the lens.
ξRefer servicing to qualified personnel only.
IMPORTANT
CAUTION: This appliance contains a low powered laser device and is classified as a CLASS 1 LASER product. The following caution label is located on the rear panel
To ensure continued safety do not remove any covers or attempt to gain access to the inside of the product.
WARNING: The laser beam used in this unit is harmful to the eyes. Do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only.
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
ξReorient or relocate the receiving antenna.
ξIncrease the separation between the equipment and receiver.
ξConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
©2003 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. SABA is a registered trademark of Thomson Corporation.
2
