Saeco Coffee Makers CAP001/A manual Coffee grinder dismantling/assembly

English

It will then be necessary to open the coffee grinder unit (ref. 19, fig. 1) and remove the cause of the jamming.

Danger

Disconnect the machine from the mains by way of the all-pole switch or disconnecting the plug, and wait for machine to be completely cooled off.

7.3.1Coffee grinder dismantling/assembly

In order to dismantle the coffee grinder the following steps must be followed:

-Dismantle both side panels and the cup heating plate (see “6.16 . Dismantling/assembly of panels”).

Danger of burns

Avoid contact with machine parts that might still be hot.

-Close the stop slide (ref. A, fig. 14) of the coffee bean hopper (ref. 7, fig. 14).

-Remove the screws (ref. B, fig. 15) from the hopper (ref. 7, fig. 15), and then slide this out of the machine by rotating it slightly upwards from the back.

7

A

fig. 14

7

B

fig. 15

20

-With the help of a vacuum cleaner remove the beans from the grinder’s inlet (fig. 16).

fig. 16

-Firstly remove the four screws (ref. C, fig. 17), then the geared wheel (ref. D, fig. 17).

CC

C

C

D

fig. 17

-Completely unscrew the adjustment ring nut (ref. E, fig. 18) and clean both the grinders using a vacuum cleaner and a brush.

Important

Verify furthermore the wear of the grinders as well as any dam- age they might have suffered and, if necessary, replace them.

E

fig. 18