Saeco Coffee Makers CAP001/A manual A D

English

Furthermore it is possible to dispose of the coffee grounds directly into a container to be placed below the machine surface top, as follows:

-drill the surface top as indicated (ref. E’, fig. 6);

-break the pre-marked diaphragm (ref. E, fig. 6) on the bottom of the grounds tray (ref. 17, fig. 1).

Important

In order to make connection operations easier, the diameter of the holes to be drilled in the surface top will have to be greater than that of the pipes and cables indicated in the legend of fig. 6.

rectly proportioned to the power drawn by the machine.

The connection point (electrical socket or all-pole switch) must be placed in a position easily reachable by the user, in order to be able to disconnect the machine from the mains, should this be necessary.

In case of installations with 400 V two-phase current, utilise the phases in such a way as to supply the machine with 230 V single- phase current (fig. 7).

Neutral (N) - Blue

Machine surface top

A' F' A' D'

C'

B'

A' E' A'

Phase (L1) - Brown

Phase (L2) - Black

Earth	- Yellow/Green
fig. 7	Power cord
	type H07RNF section 4x2,5 mm2
	Connection of plug
	to a 400 V2N~ two-phase mains line

fig. 6

MACHINE FRONT PART

Legend:

A‘ Adjustable feet

B‘ Water drain (27 mm ø tube) C‘ Water supply (19 mm ø tube)

D‘ Power mains (13 mm ø power cord) E‘ Coffee grounds tray

F‘ Single hole to replace holes B’, C’ and D’ (100 mm ø pipe).

CH

(Switzerland)

L1N N

CEI

L2

Danger

According to the norms ruling in the Country where the ma- chine is installed, the cord for the connection to the mains must be equipped either by an all-pole switch (with a mini- mum contacts’ opening clearance of 3 mm), or with a plug

L2

fig. 8

L1

conforming to the norms.

The all-pole switch must be suitable for the power drawn by the machine and able to detect all voltage polarities.

Check that the electrical cables of the installation are cor-

8

NB: For the 230V~ single-phase connection it is necessary to use the special kit (code 1020.R05) and to follow the instructions con- tained therein.

Only for EUROPEAN models