Installing the 6H122-16 into the 6C105 Chassis
To prevent damaging the backplane connectors in the following
!step, take care that the module slides in straight and properly
CAUTION | engages the backplane connectors. |
|
6.Locate the card guides that line up with the number of the slot in which the module will be installed. Install the module in the chassis by aligning the module circuit card between the upper and lower metal card guides of the desired slot, sliding it into the chassis, and locking down the top and bottom plastic locking tabs, as shown in Figure
NOTE |
When installing a module, ensure that the top plastic locking tab lines up with the desired slot number located on the front panel of the chassis. Refer to Figure
|
