Saeco Coffee Makers CAP001/A manual 5.2Insertion of Nation key, 5.3First switching on

Important

It strongly suggested that the machine be supplied with water treated through a descaling device, especially in cases of water with a high content of calcium and magnesium salts (hard water).

5.2Insertion of Nation key

Danger

Operation falling within the competence of the Maintenance technician.

The “nation key” contains the following data:

-Language shown on display.

-Setting of software according to the Country where the ma- chine is utilised.

Important

The machine WILL NOT operate without the “nation key”, so it is important to see to this operation.

The machine will only accept a single insertion of the “nation key”.

To insert the nation key it is necessary that the following operations be performed:

-Disconnect electrical power.

-Dismantle the left-hand side panel (ref. 1, fig. 1) and the glass (ref. 2, fig. 1).

-Insert the key (ref. A, fig. 9) into the connector (ref. B, fig. 9) of the electronic board.

-Re-assemble the glass and the side panel.

C
A
fig. 9	B

English

5.3First switching on

-Fill the coffee hopper (ref. 7, fig. 1) with the selected coffee bean blend.

Important

Make sure that the coffee beans don’t contain foreign bodies (pebbles, metallic elements or whatever) which could dam- age the grinders.

-Make sure that the all machine’s removable components (ref. 15 and 17, fig. 1) are in place and that the front door is closed (ref. 13, fig. 1).

On the contrary, when the machine switches on, the display (ref. 8a, fig. 1) will show which of the components is at fault.

-Connect the machine to the mains (either by setting the all-pole switch to “I” or by plugging).

-Switch machine on by way of the main switch (ref. 10, fig. 1); The display will show message “HEATING WAIT”.

-When the display shows “READY FOR USE”, it will be necessary to:

-Position the dispenser (ref. 23 and 24, fig. 1) so as to obtain a height suitable for the containers in use (see “4.3 Coffee dispenser unit”).

-Position one or two containers under the dispenser.

-Press the key corresponding to the type of drink selected.

Important

Even though initially all keya are programmed with standard values, it is necessary to check that the drink dispensed corre- sponds with the desired characteristics. If this is not the case, set again the dispensing keys (see “6.11 Programming of dispensing keys”).

5.4Serial port connection

Danger

Operation falling within the competence of the Maintenance technician.

Beside the “nation key” connector the RS 232 serial port (ref. C, fig. 9) is found.

Through this serial port it is possible to connect the machine to the devices and equipment deployed by the AUTHORISED SERVICE CENTRES for tests and programming operations.

9