Samson DMS80 owner manual Aux/Cd, Line OUT, SUB OUT Mono, Fuse, AC Inlet

ENGLISH

C O N T R O L S A N D F U N C T I O N S

NOTE: Signals to the LINE IN will be amplified only when the LINE switch on the front panel is depressed to its on position.

3.AUX/CD IN

The AUX/CD IN jacks accept audio signal input from any external CD or CD ROM player, stereo receiver, audio mixer, video board or VCR.

NOTE: Signals to the AUX/CD IN will be amplified only when the AUX/CD switch on the front panel is depressed to its in position.

4.LINE OUT

The LINE OUT provides line level output of the LINE input, AUX/CD input and MIC/INST. input signals, unaffected by the Master VOL- UME Control, BALANCE Control or GRAPHIC EQUALIZER.

5.SUB OUT MONO

Connect the SUB OUT MONO output to the line in of an additional amplifier and subwoofer or powered subwoofer system. Since sub- woofer signals are normally mono, only one cable is used between the DA80 and the subwoofer system. The SUB OUT MONO has been designed to provide +6dB of line level output gain for a sepa- rated amplifier or self contained subwoofer system equipped with a built-in amplifier.

CAUTION: Do not connect a non-amplified subwoofer speaker directly to the DA80’s SUB OUT MONO output or the warranty will be void. Damage may occur to the sub line level output circuitry.

NOTE: Plugging Headphones into the front panel headphone jack will mute any signal to the SUB OUT MONO output as well as to the

SPEAKER OUTPUTS.

6.FUSE

The fuse provides protection for the DA80. The fuse will blow if there is an overload condition, high demand for power amplification or extremely low speaker impedance. Replacement size is a standard F3A miniature fuse (5mm x 20mm) for 115V systems or T2A for 230V systems. If a fuse continues to blow, please contact Samson service at 1-800-3SAMSON (1-800-372-6766).

7.AC INLET

Connect the supplied standard 3-pin “IEC” plug to the AC INLET.

10