Samson VHF Micro TRUE DIVERSITY WIRELESS Guided Tour - VT3L, English, Samson, Power On

Guided Tour - VT3L

VT 3L

INPUT

ENGLISH

6

7

SAMSON

GAIN

POWER ▲ON

SAMSON

5

8

5:Power on-off switch* - Use this to turn the VT3Lon or off (to conserve battery power, be sure to leave it off when not in use).

6:Gain control (trimpot) - This input sensitivity control has been factory preset to provide optimum level for the particular lavalier or headset model being used and so we recommend that this not be adjusted manually. If necessary, however, you can use the supplied plastic screwdriver (see #8 below) to raise or lower the VT3L Gain control. See the “Setting Up and Using Your VM1 System” section on page 8 in this manual for more information.

7:Battery holder - Insert a standard 9-volt alkaline battery here, being sure to observe the plus and minus polarity markings shown. We recommend the Duracell MN 1604 type battery. Although rechargeable Ni-Cad batteries can be used, they do not supply adequate current for more than four hours. WARNING: Do not insert the battery backwards; doing so can cause severe damage to the VT3L and will void your warranty.

8:Plastic screwdriver - Specially designed for use in adjusting the VT3L Gain control (see #7 above) and/or VM1 Squelch control (see #5 on page 3 ). See the “Setting Up and Using Your VM1 System” section on page 8 in this manual for more information.

*Be sure to mute the audio signal at your external mixer or amplifier before turning transmitter power on or off, or an audible pop may result.

8