Time Domain Mode / Spectrum Analyze Mode
At any time, you can opt to graph different parameters for the selected receiver, or to view the data for a different receiver altogether, simply by calling up the Time Domain Configuration dialog again. To determine the actual time of any point in the graph, simply move the cursor to that point and click. A light gray vertical line will appear at that point and the time display in the upper
You can also zoom the display in or out to view specific areas of the data. The simplest method of zoom- ing in is to simply use the mouse to specify the data you want to view: Position the mouse at the start of the area you want to view, click and hold, then drag across the screen to the end of the area you want to view. When you then release the mouse, the specified area will zoom in to fill the entire screen. To restore the screen to its previous condition, simply
Alternatively, you can set various screen magnifications by using the Zoom Tools, available only in Time Domain Mode. These allow you to magnify the screen by factors of 2, 5, 10, 20, 50, or
100. To return the screen to standard magnification,Zoom Tools simply click on the “x 1” box. You can make the same
changes to screen magnification by opening the Zoom menu, available only in Time Domain Mode.
Spectrum Analyze Mode
The third, and final main mode of operation offered by WSM is Spectrum Analyze Mode. In this mode, WSM uses your connected receivers to scan through all available frequencies and then graphs out the relative RF signal strengths onscreen. This allows you to make the best channel selections, based on actual RF conditions in the performance environment of your wireless system.
To enter Spectrum Analyze Mode, either select it from the Window menu, or click on the Spectrum | |
Analyze icon in the Tool Bar. | Spectrum |
| |
In this mode, a scan and spectrum analysis can be run of all standard UR6D frequencies, | Analyze Mode |
icon | |
of all “X” UR6DX frequencies, or both sets of frequencies. If all receivers in your wireless |
|
system use the same frequencies (that is, if the system contains all UR6D receivers or all |
|
UR6DX receivers), WSM will automatically scan |
|
only those frequencies. However, if your |
|
wireless system contains both UR6D and |
|
UR6DX receivers being used simultaneously, |
|
you need to let WSM know which frequencies | Spectrum Analyze Mode |
you want scanned and analyzed. To do so, call | |
up the Group Select dialog either by opening the | Setting menu |
| |
Setting menu or by clicking on the Group Select |
|
icon in the Tool Bar. In this dialog (shown at left), |
|
you can choose the frequency range (standard | Group Select |
“B Type” UR6D frequencies or “AX Type ” UR6DX | |
“X” frequencies) you wish to analyze and specify | icon |
| |
the receiver you wish to use for scanning purposes.
15
