Launching WSM
Before launching WSM, make sure all receivers are interconnected correctly (as per the instructions given on the preceding pages) and powered on. Then boot up your computer and
When launched, WSM will automatically load the most recently created “.WSM” file, if one exists. (.WSM files contain the current channel setup, all recorded data, and the contents of all Scene Memories). It then scans all connected receivers to check that all parameters in the receivers exactly match that of the data in the file. If the data does not match, the program will display a warning dialog similar to the one shown on the right. Click on OK to continue; WSM will automatically read in all changed parameters, always reflecting the current status of connected receivers.
WSM always begins in Monitor mode, displaying the screen shown below:
1
2
3
4
5
8
6
7
See page 10 in this manual for a description of the various numbered areas.
7
