U
SING
Y
OUR
P
RINTER
ON
A
N
ETWORK
E.7
E
Setting Network Protocols
When you first install the printer, all supported network
protocols are enabled when you turn the printer on. If a network
protocol is enabled, the printer may actively transmit on the
network even when the protocol is not in use. This may increase
network traffic slightly. To eliminate unnecessary traffic, you can
disable unused protocols.
1
In ready mode press the Menu button ( ) until you see
“Network” on the bottom line of the display.
2
Press the Enter button ( ) to access the menu.
3
Press the scroll button ( or ) until “Config Network”
displays on the bottom line. Press the Enter button ( ).
4
Press the scroll button ( or ) to display “Yes” and
press the Enter button ( ). Then press the Upper Level
button ( ).
5
Press the scroll button ( or ) until you see the desired
protocol on the bottom line.
You can choose AppleTalk or Netware.
6
Press the Enter button ( ).
7
Press the scroll button ( or ) to change the setting to
“On” (enable) or “Off” (disable).
8
Press the Enter button ( ) to save the selection.
9
Press the ON Line/Continue button ( ) to return to
ready mode.