Heating Your Room (Except the cooling only models)
You can select the Heat mode only in the heat pump models.
You must select the Heat mode if you wish to adjust the:
◆Heating temperature
◆Fan speed when heating
1 If necessary, press the 
(On/Off) button.
Result: ◆ The 5 Way indicator on the indoor unit lights up.
◆ The air conditioner starts up in the mode selected when the unit was last used.
◆The indoor unit beeps.
The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆ Plugged in ◆ Stopped
It will start up normally after three minutes.
2If the 
is not displayed at the top of the remote control, press the
button on the remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the 
button.
◆The air conditioner runs in the HEAT mode.
➢ You can change modes at any time.
3 To adjust the temperature, press the 
buttons one or more times until the required temperature is displayed.
Possible temperatures are between 16°C and 30°C inclusive.
Result: ◆ Each time you press the 
buttons: - The temperature is adjusted by 1°C - The indoor unit beeps
◆The air conditioner starts heating, provided that the room temperature is lower than the desired temperature (selected temperature+3°C); the fan will, however, operate.
4 Select the fan speed by pressing the | button one or more times |
until the required setting is displayed: |
|
Automatic (rotated : | ) |
Low |
|
Medium |
|
High |
|
Result: ◆ Each time you press the | button, the indoor unit beeps. |
5 To control the direction of the air flow, refer to pages 16 and 17.
