Samsung DVD-R145 instruction manual Pages 103~105, Cable provider, Getting Connected

Antenna + Set Top Box Controller + DVD Recorder + TV : Cable box with a video/audio output or a satellite receiver

You can record channels by selecting the channel on the cable box. You cannot record one channel while watching another channel. Be sure that the cable box is turned on.

Setting Up

Connecting &

TO AV 1 IN or￿

TO AV 2 IN(on the front panel)

Getting Connected

1.Find and Connect the included Cable Box Control cable into the Cable Box Control jack of the DVD Recorder.

2.Find the Cable Box IR Sensor

To control cable box recording, find the IR sensor.

A.Turn the cable box Off.

B.Hold the cable box’s remote so that it touches

the front of the device (see Figure 1).

Figure 1

CorrectIncorrect

C. Move the remote across the front while pressing the power button On and Off (Figure 2).

16 - English

Figure 2

(Press and release the power button each time you move the remote; holding down the button will not work.)

D. When the cable box powers On, you have found the sensor. E. Remember the location of the sensor.

3.Place the Cable Box Control Wand

Place the Cable Box Control wand underneath the cable box approximately 1 inch in front of the sensor you found in 2 . Use the double-sided tape to secure the Cable Box Control wand.

	■	You must select a cable box brand from the table on
		pages 103~105.
NOTE		If you do not know the brand name, please contact your
		cable provider.

■After connecting cable box to the DVD recorder through the IR Blaster cable, you need to set up the Set Top Box Control menu. (See pages 38~39)