Using The Sound On/Off Function

Before using the product for the first time

1.While holding down the Delay Start and Half Load buttons, press the Power button to access the setting to activate/deactivate the Sound On/Off function.

2.Press the Sanitize button to activate or deactivate the Sound On/Off function.

-- “Rinse Refill ” indicator turns on to indicate that Sound On function has been activated. -- “Rinse Refill ” indicator turns off to indicate thatSound Off function has been activated.

Even though Sound Off function has been activated, the error sound plays when an error occurs.

3.To exit the Sound On/Off setting, press the Power button.

USING DISHWASHER SALT

Filling the salt reservoir

In order to use soft water, you need to fill the salt reservoir with dishwasher salt.

Use dishwasher salt only.

CAUTION Do not use any other type of salt or solvent. This may damage the salt reservoir and the water softening system.

Always fill the salt reservoir just before running one of complete washing programmes to prevent CAUTION corrosion due to the excess salt or salty water.

1.Open the door.

2.Open the salt reservoir cap by rotating it counterclockwise.

3.Fill the salt reservoir with water(only required when switching on the appliance for the first time)

4. Add the dishwasher salt.

The salt reservoir’s capacity is about 1 kg. Do not overfill the salt CAUTION reservoir.

5. Remove excess salt from around the salt reservoir opening and cap seal.

If the excess salt is not removed, the salt reservoir cap may not CAUTION close properly and allow salt water flow out with negative impact to

the performance.

6.Rotate the salt reservoir cap clockwise until it is completely shut.

Recommended that if spilled a lot of salt or salty water to inside Tub, run the Prewash to clean inside Tub. Any remaining salt grain or salty water can occur corrosion.