Samsung DW60H700FEW/TR Using The Delay Start Function, Using The Digital Display, Time display

Interrupting a programme

If you open the door while a programme is in progress, the programme is temporarily halted. To resume the programme, simply close the door.

The water in the dishwasher may be extremely hot.

CAUTION Only open the door when absolutely necessary and exercise extreme caution.

Changing a programme

If a programme has already started and you want to change it, follow the instructions below: If the detergent dispenser flap has been opened, do not change the programme.

1.Open the door to interrupt the programme.

2.Push and hold the Start/Reset button for 3 seconds to reset the programme.

• Once the programme is reset, the dishwasher will perform a 1 minute drain. You will be able to change the programme once the draining ends.

•To skip the draining process, press the Power button to turn the dishwasher off and then press the button again to turn it back on.

You will have to select additional functions again.

3.Change the programme and push the Start/Reset button.

4.Close the door to start the new programme.

USING THE DELAY START FUNCTION

You can set the dishwasher to start a programme at a later time by choosing a delay of between 1 and 24 hours (in 1 hour increments).

1.Open the door and load the baskets.

2.Add the appropriate amount of dishwasher detergent into the dispenser and on the door (if required).

3.Push the Power button to turn on the dishwasher.

4.Select the programme and functions.

5.Set the delay time using the Delay Start button.

6.Push the Start/Reset button. The Delay Start indicator lights up, and the clock begins to count down.

7.To cancel the Delay Start function, press and hold the Start/Reset button for 3 seconds to reset the programme.

USING THE DIGITAL DISPLAY

The digital display shows the remaining wash time, status information (Delay Start, Salt Refill, Rinse Refill, and Child Lock) and error codes.

If an error occurs while the product is operating, the code associated with the error is displayed and a beeping sound will be played. Refer to the “Information codes” section on page 33.

Time display

The time display area indicates the time remaining until the end of the selected programme in hours and minutes.

The time remaining may vary even with the same programme. This can be due to difference in water temperature, the reactivation cycle, and the size and state of the load.

26_  Operating your dishwasher

DD68-00093D-06_S07_140428_EN.indd 26

28/4/2014 16:45:18