English - 18

INSTALLATION
Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a

cable TV system (according to the instructions on pages 14~17). Skip step 1if you have not

yet connected to an antenna or a cable system.

1
Connect a coaxial cable between the “ANT 1 IN (Air)”
(or “ANT 2 IN (Cable)”) terminal on the TV and the
antenna out terminal on the VCR.
A coaxial cable is usually included with a VCR. (If
not, check your local electronics store).
2
Connect a set of audio cables between the “AV IN 1
(L, R)”(or “AV IN 2 (L, R)”) jacks on the TV and AUDIO
OUTjacks on the VCR.
If you have a mono VCR, connect L(mono) to VCR
audio out using only one audio cable.
3
Connect a video cable between the “AV IN 1 (VIDEO)”
(or “AV IN 2 (VIDEO)”) jack on the TV and the VIDEO
OUT jack on the VCR.
Follow the instructions in “Viewing a VCRor
Camcorder Tape” to view your VCR tape.

•Also, you can connect to “AV 3” on the side panel of TV.

TV Rear Panel
From Cable
Coaxial Cable
From Antenna
Video
Cable
Audio Cable

VCR Rear Panel

1
2
3
BP68-00334B-00Eng 2005/02/15 04:38 PM Page 18