![](/images/new-backgrounds/1329935/32993523x1.webp)
Connections
✎If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic field.
✎Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, sound from the speakers may be disrupted because of interference.
✎If you use a device such as a microwave oven, wireless LAN Card, Bluetooth device, or any other device that uses the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference.
✎The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary depending on your operating environment. If a
✎If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless receiver module. With the product turned off, press "0""1""3""5" on the remote control. Turn on the wireless receiver module. Then, press and hold the "ID SET" button on the back of the wireless receiver module for 5 seconds, and then turn the product on.
CAUTION
If you want to install the speakers on the wall, fasten screws or nails (not provided) firmly to the wall wherever you want to hang a speaker, and then, using the hole in the rear of each speaker, carefully hang each speaker on a screw or nail.
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
When connecting the speaker wires to the speakers, make sure that the polarity
Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien substances into the duct (hole) of the subwoofer speaker.
Do not hang the subwoofer on the wall using the duct (hole).
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.
In
Attaching the Toroidal Ferrite Core to the Power Cord of the Wireless
Receiver Module
* HT-H5550WK only
If you attach a Toroidal ferrite core to the power cord of the wireless receiver module, it will help prevent RF interference from radio signals.
1.Pull the fixing tab of the Toroidal ferrite core to open it.
2.Make two loops in the wireless receiver module power cord.
3.Attach the Toroidal ferrite core to the wireless receiver module
power cord as shown in the figure on the right, and then close it by pressiing it until it clicks.
• Attach the ferrite core as close to the Wireless Receiver Module as possible.