Connections
Installing the Speakers on the Half Tallboy Stand
* HT-H5530HK only - Front Speakers
1.Turn the Stand Base
2.Use the driver to combine the screws on the 3 marked holes. Installing a speaker is finished. Follow the same steps to install other speakers.
3.If you want to adjust the height of the speaker, loosen a screw on the rear of the speaker base first.
4.Pull up the speaker in the arrow direction. (Be careful as an excessive force may result in a physical damage.)
5.Fit the speaker in a height adjusting a hole, and then use a screw to fasten a speaker.
6.This is appearance of after the speaker is installed and height adjusted. To adjust height of other speakers, follow the step 3 ~ 5.
Installing the Speakers on the Tallboy Stand
1 Stand Base | 2 |
Speaker
34
5 | 6 |
or
*
*
1.Turn the Stand Base
2.Use the driver to combine the screws on the 3 marked holes.
3.Straighten a supplied speaker wire to the gravity direction and put in the hole on the centre of Stand Base.
4.Connect the upper Speaker to the assembled Stand.
5.Insert a screw clockwise into the hole on the rear of the speaker using a screwdriver.
And then connect a speaker cable.
6.This is the appearance after the speaker is installed. Follow this steps to install other speaker.
1 Stand Base | 2 |
Stand
3
4
Speaker
Stand
56
