Settings
2)Set the Anynet+
3)Search for and then select the product in the TV's Anynet+
Support
Remote Management
When activated, lets Samsung Call Center agents diagnose and fix problems with the product remotely. Requires an active Internet connection. Remote Management service might not be available in some countries.
Software Update
For more information about the Software Update function, see "Upgrading Software" on page 24.
Use Mode
Lets you set the Use Mode. If you are using the home theater at home, always select Home Use. Store Demo is for retail display settings only.
Contact Samsung
Provides contact information for assistance with your product.
Reset
Reverts all settings to their defaults except for the network and Smart Hub settings. Requires that you enter your security PIN. Press and hold the 123 button until the Num pad appears on the screen. When the Num pad appears, select a number using the ,.
button and then press the OK button. The default security PIN is 0000.
Network Setup
When you connect this product to a network, you can use network based applications and functions such as Smart Hub and
Configuring Your Network Connection
If you didn't configure your network connection during the initial settings procedure or you need to reset the network connection, follow the directions below.
Before you begin, contact your Internet Service Provider to find out if your IP address is static or dynamic. If it is dynamic, and you have a wired or wireless network, we recommend using the Automatic configuration procedures described below.
If you are connecting to a wired network, connect the product to your router using a LAN cable before you start the configuration procedure.
To begin configuring your network connection, follow these steps:
1.In the Home screen, select Settings, and then press the OK button.
2.Select Network, and then press the OK button.
3.Select Network Settings, and then press the OK button.
4.Go to the instructions for Wired networks starting below or the instructions for Wireless networks starting on page 21.
Wired Network
ĞĞWired – Automatic
After following Steps 1 to 3 above:
1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the OK button. The product detects the wired connection, verifies the network connection, and then connects to the network.
2.When it is done, highlight OK, and then press OK button.
