Samsung HT-H6500WM Network Settings, Wireless Network, ĞĞ Wired Manual, ĞĞ Wireless Automatic

21 - English

ĞĞWired - Manual

If you have a static IP address or the automatic procedure does not work, you'll need to set the Network Settings values manually.

After following Steps 1 to 3 above:

1.In the Network Settings screen, change Network type to Wired. Then, select Connect and press the OK button.

The product searches for a network, and then displays the connection failed message.

✎✎ If it is possible to connect the home theater to your network wirelessly, select Change Network at this point, change the Network type to Wireless, and then go to the instructions for wireless networks on this page.

Network Settings

Wired network connection failed.

MAC Address	XX:XX:XX:XX:XX:XX
IP Address	0.	0.	0.	0
Subnet Mask	0.	0.	0.	0
Gateway	0.	0.	0.	0
DNS Server	0.	0.	0.	0

Unable to connect to the network. Try the following: check if your IP address is set ~ correctly in IP Settings. Contact your Internet Service Provider for more information.

Change Network IP Settings Retry Close

✎✎ You can get the network parameter values from your Internet provider.

7.When finished entering all the parameter values, select OK, and then press the OK button. The home theater verifies the network connection and then connects to the network.

Wireless Network

You can set up a wireless network connection in three ways:

-- Wireless Automatic -- Wireless Manual -- WPS(PBC)

Before you configure the wireless network connection, disconnect any wireless network devices currently connected to the product or, if applicable, the product's current wired connection.

ĞĞWireless - Automatic

After following Steps 1 to 3 in "Configuring Your Network Connection" on page 20:

1.In the Network Settings screen, change Network type to Wireless. The product searches for and then displays a list of the available networks.

Settings

2.	Use the	buttons to select IP Settings,
	and then press the OK button. The IP Settings
	screen appears.
3.	Select the IP Setting field, and then set it to
	Enter manually.
4.	Select a parameter to enter (IP Address, for
	example), and then press OK. Use the ,.
	buttons on the remote control to enter the

Network Settings

Select your network type.

Network type Wireless

Wireless network

si-ap

iptime

KIMING_VTOWER

You can connect your Blu-~ ray player to the internet. Please select which wireless ~ network to use.

numbers for the parameter. Or use the Num
keypad to enter a parameter number. Press and
hold the 123 button until the Num pad appears
on the screen. When the Num pad appears,
select a number using the ,.	button and
then press the OK button. Use the
buttons on the remote control to move from
entry field to entry field within a parameter.
When done with one parameter, press the
OK button.
5. Press the , or . button to move to another
parameter, and then enter the numbers for
that parameter following the instructions in
Step 4.
6. Repeat Steps 4 and 5 until you have filled in
all parameters.

Refresh WPS(PBC)

2.Select the desired network, and then press the OK button.

3.On the Security screen, enter your network's security code or pass phrase.

Enter letters by selecting a letter with ,.

buttons, and then pressing OK button.

4.When finished, select Done, and then press the OK button. The product verifies the network connection and then connects to the network.