Wireless Network
You can connect the Receiver to your network through a wireless IP sharer (router). To set the network configuration options. see page 47.
Broadband service
Wireless IP sharer 
PC
02 Connections
Networking with PC for AllShare function (See page 79)
✎NOTE
To use a wireless network, your product must be connected to a wireless IP sharer (router). If the wireless IP sharer supports DHCP, your product can use a DHCP (dynamic) or static IP address to connect to the wireless network.
This product supports IEEE 802.11b,g and n. We recommend using IEEE 802.11n. When you play video over a IEEE 802.11b or g connection, the video may not play smoothly.
Select a channel for the wireless IP sharer that is not currently being used. If the channel set for the wireless IP sharer is currently being used by another device nearby, this will result in interference and communication failure.
If you select the Pure
If your router supports WPS
You can set up the wireless network connection in three ways:
-Using Auto Setup (the Auto Network Search function) through Wireless (General)
-Using WPS(PBC)
-Using One Foot Connection
Wireless LAN, by its nature, may cause interference, depending on the operating conditions. (router performance, distance, obstacles, interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode.
The home theater supports the following security protocols only:
1)Authentication Mode : WEP, WPAPSK, WPA2PSK
2)Encryption Type : WEP, AES
To use the AllShare function, you must connect your PC to your network as shown in the figure. The connection can be wired or wireless.
English 33
