Setup
✎NOTE
Channel status displays are dependent on the speaker configuration.
SFE mode works with
If Dolby Pro Logic IIz is set to On, Dolby true HD, Dolby plus,
DPL IIx
•Panorama : You can set it On or Off.
(This mode extends the front stereo image to include the surround speakers for an exciting "wraparound" effect with side wall imaging.)
•Dimension : You can set from
•Center Width : You can set from 0 to 7.
(This sets the width of the center sound image. The higher the setting, the less sound comes from the center speaker.)
Extended Surround (EX/ES)
When surround back speakers are connected, you can listen to 6.1 or 7.1
•Auto : If the unit receives an audio signal that it can recognize, it will select an optimal decoder for playback in 6.1/7.1 channels.
If the amplifier does not recognize the audio signal, it will not play in 6.1/7.1 channel automatically.
•Off : Dolby Digital Surround EX / DTS ES decoder will not be used for playback.
•On : Dolby Digital or DTS signal will be played in 6.1 / 7.1 channel using Dolby Digital Surround EX / DTS ES decoder.
✎NOTE
You cannot use
DTS Neo:6 Center Image
You can play back 2 channel sound over 6.1 channels when enjoying music or a movie.
•You can set Center Image from 0 to 5.
This parameter adjusts the height of the center image through the front and center speakers. “0” is the lowest while “5” is the highest.
✎NOTE
NEO:6 mode cannot be used with Dolby Digital, Dolly Digital Plus, Dolby True HD, DTS,
Pro Logic works only for PCM audio signals with sampling frequencies of 32KHz, 44KHz or 48KHz.
Crossover Frequency
Select the crossover frequency for the best bass response in your speakers.
•You can set frequencies 60, 80, 100,120, 150, 180 or 200(Hz).
MP3 Enhancer
This also helps enhance your sound experience (ex. mp3 music). You can upscale your MP3 level sound (24 kHz, 8bit) to CD level sound (44.1 kHz, 16bit).
Smart Volume
This will regulate and stabilize the volume level against a drastic volume change when changing channels or during a scene transition.
