11.General Precautions
11.1Handling
(a)When the Module is assembled, it should be attached to the system firmly using all mounting holes. Be careful not to twist and bend the Module.
(b)Because the inverter use high voltage, it should be disconnected from power before it is assembled or disassembled.
(c)Refrain from strong mechanical shock and / or any force to the Module.
In addition to damage, this may cause improper operation or damage to the Module and CCFT back light.
(d)Note that polarizers are very fragile and could be damage easily.
Do not press or scratch the surface harder than a HB pencil lead.
(e)Wipe off water droplets or oil immediately. If you leave the droplets for a long time, staining or discoloration may occur.
(f)If the surface of the polarizer is dirty, clean it using absorbent cotton or soft cloth.
(g)Desirable cleaners are water, IPA(Isopropyl Alcohol) or Hexane.
Do not use Ketone type materials(ex. Acetone), Ethyl alcohol, Toluene, Ethyl acid or Methyl chloride. It might permanent damage to the polarizer due to chemical reaction.
(h)If the liquid crystal material leaks from the panel, it should be kept away from the eyes or mouth . In case of contact with hands, legs or clothes, it must be washed away with soap thoroughly.
(i)Protect the Module from static, or the CMOS Gate Array IC would be damaged.
(j)Use
(k)Do not disassemble the Module.
(l)Do not pull or fold the lamp wire.
(m)Do not adjust the variable resistor located on the Module.
(n)Protection film for polarizer on the Module should be slowly peeled off just before use so that the electrostatic charge can be minimized.
(o)Pins of I/F connector should not be touched directly with bare hands.
| MODEL | Doc. No | Page | 26 / 28 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|