The total time in seconds to complete off-line data collection activity word specifies how may seconds the device requires to complete its sequence of off-line data collection activity. Valid values for this word are from 0001h to FFFFh.
Self-test execution status byte
The self-test execution status byte reports the execution status of the self-test routine.
Bits (3:0) (Percent Self-Test Remaining)
The value in these bits indicates an approximation of the percent of the self-test routine remaining until completion in ten percent increments. Valid values are 9 through 0. A value of 0 indicates the self-test routine is complete. A value of 9 means 90% of total test time remaining.
Bits (7:4) (Self-test Execution Status)
The value in these bits indicates the current Self-test Execution Status.
| Table 8-19 Self-test Execution Status Values |
| |
Value | Description |
0 | The previous self-test routine completed without error or no self-test has ever been run |
1 | The self-test routine was aborted by the host |
2 | The self-test routine was interrupted by the host with a hardware or software reset |
3 | A fatal error or unknown test error occurred while the device was executing its self-test |
| routine and the device was unable to complete the self-test routine. |
4 | The previous self-test completed having a test element that failed and the test element |
| that failed is not known. |
5 | The previous self-test completed having the electrical element of the test failed. |
6 | The previous self-test completed having the servo (and/or seek) test element of the test |
| failed. |
7 | The previous self-test completed having the read element of the test failed. |
8 | The previous self-test completed having a test element that failed and the device is |
| suspected of having handling damage. |
9-14 | Reserved. |
15 | Self-test routine in progress. |
Total time to complete off-line data collection
The total time in seconds to complete off-line data collection activity word specifies how many seconds the device requires completing the sequence of off-line data collection activity. Valid values for this word are from 0001h to FFFFh.
Off-line data collection capability
The following describes the definition for the off-line data collection capability bits. If the value of all of these bits is equal to zero, then this device implements no off-line data collection.
Bit 0 (EXECUTE OFF-LINE IMMEDIATE implemented bit) – If the value of this bit equals one, then the SMART EXECUTE OFF-LINE IMMEDIATE command is implemented by this device. If the value of this bit equals zero, then the SMART EXECUTE OFF-LINE IMMEDIATE command is not implemented by this device.
Bit 1 (vendor specific)
Bit 2 (abort/restart off-line by host bit) – If the value of this bit equals one, then the device shall abort all
off-line data collection activity initiated by an SMART EXECUTE OFF-LINE IMMEDIATE command upon receipt of a new command. Off-line data collection activity must be restarted by a new SMART EXECUTE OFF-LINE IMMEDIATE command from the host. If the value of this bit equals zero, the device shall suspend off-line data collection activity after an interrupting command and resume off-line
Spinpoint M9T Product Manual REV 1.0 | 69 |
