9.Press Start/Enter. The LCD displays the current time on the upper line and asks you to enter the time when the fax is to be sent.
CURRENT 02:30PM
START 02:30PM
10.If you want to send it at a later time, enter the time you want your machine to send the document. If you want to send the document immediately, skip over this step.
Enter the time in same format (12/24 hour) as current time.
If you set a time earlier than the current time, the document will be sent at that time on the following day.
Note: AM or PM is selected by pressing for the " or ❷ buttons.
11.Press Start/Enter when the time appears correctly in the LCD. The document will be scanned into memory before transmission. The LCD displays the memory capacity and the number of pages.
SCAN TO MEMORY 95% P. 001
TOTAL PAGES=007
Note: You can change your machine not to scan the document into memory automatically. Refer to ‘Send from memory’ under ‘User options’ on page
2.46.If you turn this feature off, the LCD prompts you at this step to choose either to scan into memory before transmission or not.
If you cannot fit all the pages in memory, the machine automatically begins to send the document without waiting all the pages are scanned. But if you registered delayed transmission at step 10, the LCD displays ‘MEMORY FULL’ and ‘CANCEL ?.’
To cancel the job, press 1. If you press 2, the pages already scanned will be sent, and you should send the remaining pages in a separate operation.
The machine returns to standby mode.
18-JUL-1998 95% CONF. TX 03:30PM
Note: To cancel the confidential transmission setup, see ‘Canceling a standby operation’ on page 2.16.
In case a document loaded in the automatic document feeder, you cannot perform any more tx job such as delay Tx, conf. Tx, and Tx poll unless the document is sent out.
2.22 Receiving a fax
