Samsung PE40C user manual System, Multi Control

7System

7.1Multi Control

MENU [m] System Multi Control ENTER [ ]

Assign an individual ID to your product.

7.1.1 Configuring settings for Multi Control

ID Setup

Assign an ID to a set. (Range: 0~99)

Press or to select a number, and press [ ].

ID Input

Enter the ID number of the product connected to the input cable for input signal reception. Enter the number you want using the number buttons on the remote control.

MDC Connection

Select a method to connect to MDC to receive the MDC signal.

RS232C MDC

Communicate with MDC via the RS232C-stereo cable.

RJ45 MDC

Communicate with MDC via the RJ45 cable.

DisplayPort daisy chain(DisplayPort Daisy Chain)

To display the [DP IN] video input through the [DP OUT] output port, select a device connection method from Single Stream Transport (SST) and Multi Stream Transport (MST).

Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on two display devices connected.

- If Clone is selected, the PC recognizes the two displays as a single monitor.

-Clone mode is enabled if the input source is a digital input other than DisplayPort, such as DVI, HDMI, MagicInfo or PIM.

Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two display devices connected.

- If Expand is selected, the PC recognizes the two displays as separate monitors.

-The mode functions only on a PC that supports DisplayPort 1.2 MST.

-For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.

Refer to page 74 for details about the MDC menu.

7 System 145