Adjusting the PDP Display

Removes noise such as vertical stripes. Coarse adjustment may move the screen image area. You may relocate it to the center using the horizontal control menu.

Fine

MENU → → ENTER → [Picture] → → → → → ENTER → [Image Lock] → →

ENTER → [Fine] → , → ENTER

Removes noise such as horizontal stripes. If the noise persists even after Fine tuning, repeat it after adjusting the frequency (clock speed).

H-Position

MENU → → ENTER → [Picture] → → → → → ENTER → [Image Lock] → →

→ENTER → [H-Position] → , → ENTER

Adjusts the screen location horizontally.

V-Position

MENU → → ENTER → [Picture] → → → → → ENTER → [Image Lock] → → →

→ ENTER → [V-Position] → , → ENTER

Adjusts the screen location vertically.

Auto Adjustment

MENU → → ENTER → [Picture] → → → → → → ENTER → [Auto Adjustment ]

The values of Fine, Coarse, Position are adjusted automatically. By changing the resolution in the control panel, the auto function is performed.

(Available in PC mode only)

Note

The direct button on the remote control is the 'AUTO' button.

Signal Balance

This is used to make up for the weak RGB signal transmitted by a long signal cable.

MENU → → ENTER → [Picture] → → → → → → → ENTER → [Signal Bal-

ance]

(Available in PC mode only)