SETTING UP THE REFRIGERATOR

Now that you have your new refrigerator installed and in place, you are ready to set up and enjoy the full features and functions of the appliance.

By completing the following steps, your refrigerator should be fully operational.

If not, first check the power supply and electricity source or try the troubleshooting section at the back of this user guide.

If you have any further questions, contact your Samsung Electronics service center.

1.Place the refrigerator in an appropriate location with reasonable clearance between the wall and the refrigerator.

Refer to installation instructions in this manual.

2.Before using the refrigerator please remove the shelf corner covers shown on below figure. (The covers are used to secure your refrigerator during transportation).

3.Once the refrigerator is plugged in, make sure the interior light comes on when you open the doors.

4.Set the temperature control to the coldest temperature and wait for an hour.

The freezer should get slightly chilled and the motor should run smoothly.

5.After powering the refrigerator, it will take a few hours to reach the appropriate temperature. Once the refrigerator temperature is sufficiently cool, you can store food and drink in the refrigerator.

After powering the refrigerator, the alarm will sound. Press Freezer or Fridge button. (Only for Coolselect zone funtion model ) Refer to on page 23 “Using the control Panel”.

REVERSING THE DOOR (OPTIONAL)

Before you reverse the refrigerator door, make sure to unplug the refrigerator. Samsung recommends that reversing of the door opening is only completed by Samsung approved Service providers. This will be on a chargeable basis and at the customers expense.

Any damage caused while attempting to reverse the door opening is not covered under the appliance manufactures warranty.

Any repairs requested due to this circumstance will be completed on a chargeable basis at the customers expense.

1.Before attempting to reverse the refrigerator doors ensure that the refrigerator is disconnected from the main electricity supply and all food stuffs are emptied from inside the appliance.

2.If the customer does not feel confident to follow instruction in the user manual, a Samsung qualified service engineer must be contacted to carry out this change.

3.Do not plug in Refrigerator just after door reverse finished process and wait for at least one hour.

Required Tools

Not provided

Phillips Head

Flat Head Driver

11 mm Wrench

Driver (+)

(-)

(for hinge shaft)

Not provided

Additional part

8 mm Socket

 

 

Wrench

Hinge Cover / Cap Space Door

(for bolts)

 

 

18_ setting up

DA68-02833S-18.indb 18

2017. 7. 26. �� 2:27