RE-ATTACHING THE REFRIGERATOR DOORS
To reattach the fridge doors after you have moved the fridge to its final location, assemble the parts in reverse order.
1.The Water Line must be fully inserted into the center of the transparent coupler (Type A) or the Guide Lines (Type B) to prevent water leakage from the dispenser.
Type A | Type B | |
| Dispenser | |
Center of Transparent coupler | The Guide Lines | |
| ||
clip A (1/4”) | clip A (1/4”) | |
(6.35 mm) | ||
(6.35 mm) | ||
|
When reassembling it, be sure to connect CAUTION the wire harness.
If it is not connected, the Flex Room does not work.
4.Remove 1 hex head bolt from each side with a socket wrench (10mm).
2. Insert the clip in the install pack and check that it holds the line firmly.
DISASSEMBLING THE FLEX |
|
DOOR | 5. Lift up the Flex door from the rails. |
1. Take out the Flex Zone ( 1 ) by lifting it up.
1
2.Take off the cover ( 2 ) w/harness with a flat- blade screwdriver
2
3.Press the locking tab and separate the Wire Connector.
Putting too much food into the freezer CAUTION drawers can prevent the freezer from closing completely and can cause frost
