Lever
Both control levers must be touching the CAUTION floor to avoid possible personal injury or
property damage because of tipping.
If the right side is lower, perform the same procedure, but with the right control lever.
It is difficult to remove the cover leg front from the refrigerator, so we do not recommend making small adjustments with the control lever. Instead, refer to the next page for the best way to make minor adjustments to the doors.
MAKING MINOR ADJUSTMENTS TO THE DOORS
Remember, a leveled refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator.
Fixed part | Adjustment |
part |
The left door is fixed. To make minor door adjustments, adjust only the right door.
1.Pull out the flex door ( 1 ) to reveal the lower hinge ( 2 ).
2.Insert the supplied allen wrench (5/32”) ( 3 ) into the shaft ( 4 ) of the lower hinge.
3.Adjust the height by turning the hex wrench ( 3 ) clockwise ( DOWN ) or counter clockwise ( UP ).
When you turn the hex wrench counter-
clockwise (
), the door will move up.
14_ setting up
2 |
|
3 | 3 |
4 |
|
1
INSTALLING THE WATER DISPENSER LINE
A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. The water line also connects to the ice maker.
For the ice maker to operate properly, water
pressure of
If the refrigerator is installed in an area with low water pressure (below 20 psi), you can install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Water line installation kits are available at extra cost from your dealer.
We recommend using a water line installation kit that contains copper tubing and ¼” compression nut.
Connecting to the water supply line
1. First, shut off the main water supply.
2.Locate the nearest cold water drinking line and install the pipe clamp and shut off valve.
Cold water line
Pipe clamp
Shut off valve
